Thanks Thanks:  0
Likes Likes:  1
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: ELAN Integration with HWQS

  1. #1
    Junior Member
    Join Date
    May 2015
    Posts
    1

    ELAN Integration with HWQS

    I am having an issue integrating an ELAN HC6 controller with a Homeworks QS system over IP. Both systems are setup with static IP addresses and the ELAN system should simply discover all of the devices on the Lutron QS system; when I attempt to discover the system from the ELAN side I am only able to see about 60% of the loads, all of the keypads import fine but some of the loads are not discovered. There does not seem to be any discernible pattern to which loads are not imported and I don't know if this is an ELAN issue or a Lutron issue. Has anyone run into this problem integrating with ELAN or any other interface?

    Lutron Equipment:
    2x HWQS processors
    15x Wired Keypads
    2x Power Panels with assorted modules


    Thanks

    Nate

  2. #2
    Senior Member
    Join Date
    Oct 2013
    Posts
    433
    Have you seen this document explaining what devices from lutron are compatible

    http://www.elanportal.com/supportdoc...works%20QS.pdf

    Im not familiar with this but seems like maybe the loads on the RPM modules may not be discovered. The doc does list devices that are compatible

  3. Likes Armando B. liked this post

Similar Threads

  1. Troubleshooting 3rd-party integration issues with HWQS
    By Ty W. in forum 3rd-party Integration - HWQS
    Replies: 17
    Last Post: 12-17-2014, 04:34 PM
  2. Troubleshooting 3rd-party integration issues with HWQS
    By Ty W. in forum Troubleshooting - HWQS
    Replies: 1
    Last Post: 07-19-2013, 05:33 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •