-
DALI Load type problem
I don't know if anyone has spotted this,
When you make a DALI LED fixture and you set the low end level to 1%.
When you go to add a circuit or load with that load type it comes back with a Low end of 10%
Annoying !!
Any ideas !!
Thanks
PS I am using 7.4 or 8.1 with the same effect.
-
Edit fixtures/dimming range
Set to 1% and then you can change the low end
This worked for me on 8.1. Haven't tried it on 7.x though
-
nope
![Quote](images/misc/q.gif)
Originally Posted by
LightBrigade
Edit fixtures/dimming range
Set to 1% and then you can change the low end
This worked for me on 8.1. Haven't tried it on 7.x though
Tried what you did on 7.4 and 8.1
It did not work.
I made a new fixture, set the low end to 1% and the Dimmer range to 1%.
Then went to the load page.
entered a new load with the new fixture type that the low end reads 10% !!!!!
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
-
Authorized Lutron Contributor
Thank you for this feedback; we are able to reproduce this and will work with our software team to fix it in a future release.
-
Sorry abutchart - looks like you found an issue! Not sure why it isn't consistent though?!