Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: HWQS RF devices

  1. #1
    Senior Member
    Join Date
    Sep 2013
    Posts
    424

    Talking HWQS RF devices

    Hi All
    So a current project grew enough that we need to add an additional RF link to support more RF wallbox devices.
    I'd like to keep the number of RF repeaters the same, so I'm reassigning 1 RF repeater out of 3 to a new processor, and moving the RF devices closest to that repeater to the new RF link on the new processor as well.
    Unfortunately, that means I need to factory reset and re-activate all the devices. Fair enough. But could you please update the QS program so the serial number of already-activated RF devices 'stick' to the devices I'm moving around? I think I can open an older version of the program to find out what the SN are and then manually input them into the new link, but I would really value QS keeping that info attached to the device until I intentionally delete the serial number.
    This is lower in priority than my request to have QS store/recall my column width preferences.

  2. #2
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    513
    Thank you for this feedback.

Similar Threads

  1. Re-setting question-main repeater and all devices
    By SERVICEELE1 in forum General Discussion - RA2
    Replies: 2
    Last Post: 11-14-2014, 08:32 AM
  2. Problems in Activate devices in QS link
    By marcelo in forum Troubleshooting - HWQS
    Replies: 3
    Last Post: 07-31-2014, 10:42 AM
  3. Verifing loads and devices in HomeWorks QS
    By darthcatcher5 in forum Troubleshooting - HWQS
    Replies: 1
    Last Post: 01-21-2014, 10:09 AM
  4. Clear Connect / Staples Connect Devices
    By az1324 in forum General Discussion - Controls
    Replies: 12
    Last Post: 10-29-2013, 11:45 AM
  5. Minimum Loads for HWQS Devices
    By Armando B. in forum General Discussion - HWQS
    Replies: 2
    Last Post: 10-09-2013, 11:33 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •