Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Programming a WPM in QS

  1. #1
    Junior Member
    Join Date
    Aug 2014
    Posts
    8

    Programming a WPM in QS

    I have new project and we do not have enough room for a 3rd PNL-5 so we are going to use 4 LQR-WPM-6P instead. I am curious to know how they work as far as programming and assigning zones to them etc. Any help is appreciated

  2. #2
    Authorized Lutron Contributor
    Join Date
    Jun 2013
    Posts
    91
    The WPM zones are assigned in a similar way to the RPM loads, except the WPM is in the Design/Controls screen, not the Design/Equipment screen.
    The WPM is a 'forward phase only' device.
    It can be addressed on either a wired QS link or an RF link.
    It has the same 2000W max per unit limit that the RPM-4U has.

    The specification sheet can be found here:
    http://www.lutron.com/TechnicalDocum...HWQS%20WPM.pdf

Similar Threads

  1. Execute Double Tap Programming without the Press programming
    By Armando B. in forum Programming - Legacy HW
    Replies: 0
    Last Post: 11-12-2013, 11:52 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •