Thanks Thanks:  0
Likes Likes:  0
Results 1 to 2 of 2

Thread: IR Receiver Options

  1. #1
    Junior Member
    Join Date
    Oct 2013
    Posts
    16

    IR Receiver Options

    Can the QSE-IR-WH be used with HomeWorks QS wired to the QS Link? It doesn't seem to be in the Tool Box. Does it have a serial number on it? With HW Illumination we had a few options to use for IR (CCI-8 etc). It would be nice to have a low-cost IR receiver which could be installed at an A/V equipment rack. It's expensive to hide a SeeTouch w/IR keypad behind an equipment rack.

  2. #2
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    513
    Thank you for the post. Please see the thread below as it talks goes over the topic in this post.

    https://forums.lutron.com/showthread...76-IR-Commands

Similar Threads

  1. Lamp Dimmer options
    By mdfeather in forum Programming - CAS
    Replies: 4
    Last Post: 03-07-2016, 07:09 PM
  2. RF Receiver Rapid Red Flashing
    By Anna W. in forum Troubleshooting - Shades
    Replies: 6
    Last Post: 11-21-2014, 11:05 AM
  3. What is the difference between different LED Logic options
    By Craig W. in forum Design Assistance - HWQS
    Replies: 3
    Last Post: 02-28-2014, 12:45 PM
  4. The end of the incandescent - what are our options?
    By totalcontrol in forum General Discussion - RA2
    Replies: 9
    Last Post: 02-16-2014, 11:02 PM
  5. Motor Load Options Explained
    By Armando B. in forum Programming - HWQS
    Replies: 0
    Last Post: 08-21-2013, 06:08 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •