Results 1 to 1 of 1

Thread: Two Occupancy Sensors in Different Areas Sharing a Light

  1. #1
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    513

    Two Occupancy Sensors in Different Areas Sharing a Light

    Attached is a sample project file in version 7.4 of the HomeWorks QS software that has the following functionality

    When sensor 1 goes occupied zones 1 and 3 turn on
    When sensor 1 goes unoccupied it will turn off zones 1 and 3 if sensor 2 is unoccupied. If sensor 2 is occupied then sensor 1 will only turn off zone 1

    When sensor 2 goes occupied zones 2 and 3 turn on
    When sensor 2 goes unoccupied it will turn off zones 2 and 3 of sensor 1 is unoccupied. If sensor 1 is occupied then sensor 2 will only turn off zone 2.

    To accomplish this programming no variables are used but the sensor programmed as conditional.

    Sensor 1: There are 3 actions. There is a “Light on” action that turns on zones 1 and 3. There is a “Light 1 off” action that turns zone 1 off. There is a “Lights 1 and 3 off” action that has both zones 1 and 3 turning off. On the Occupied tab of the senor the run the “Lights on” scene. In the Unoccupied tab there is conditional that if sensor 2 is occupied run the “Light 1 off” scene else run the “Lights 1 and 3 off” scene.

    Sensor 2: There are 3 actions. There is a “Light on” action that turns on zones 2 and 3. There is a “Light 2 off” action that turns zone 2 off. There is a “Lights 2 and 3 off” action that has both zones 2 and 3 turning off. On the Occupied tab of the senor the run the “Lights on” scene. In the Unoccupied tab there is conditional that if sensor 1 is occupied run the “Light 2 off” scene else run the “Lights 2 and 3 off” scene.
    Attached Files Attached Files

Similar Threads

  1. Occupancy/vacancy sensors
    By Ekkoville in forum General Discussion - CAS
    Replies: 5
    Last Post: 04-14-2016, 02:46 PM
  2. QSE-IO and 3rd-party occupancy (motion detection) sensors
    By virtual in forum Design Assistance - HWQS
    Replies: 1
    Last Post: 09-30-2014, 03:42 PM
  3. Dual Occupancy Sensors
    By schalliol in forum General Discussion - RA2
    Replies: 4
    Last Post: 09-30-2014, 09:34 AM
  4. GRX-IRPS-WH Partition Sensors
    By jwbcinergy in forum Programming - HWQS
    Replies: 1
    Last Post: 08-28-2014, 12:19 PM
  5. Pico and Occ Sensors out of programming
    By mandbelectric in forum Troubleshooting - RA2
    Replies: 1
    Last Post: 12-31-2013, 04:11 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •