Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 1 of 1

Thread: Raise and Lower Using Phantom Keypads and Integration

  1. #1
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    513

    Raise and Lower Using Phantom Keypads and Integration

    Attached is a sample project file programmed with the application described below.

    We have an RPM with 4 zones, 1 through 4. We then have a phantom keypad with four buttons: scene 1, scene 2, raise, and lower. Then, we have a variable. Its called “phantom scenes” its default state is none, and its other states are scene 1 and scene 2. The idea for the variable is for it to have as many states as there are scene we should raise and lower.

    On the scene 1 button of the phantom keypad, the variable is set to “scene 1” and the first two zones are sent to 100%. On button scene 2 of the phantom keypad, zones 3 and 4 are sent to 100% and the variable is set to scene 2.

    The raise and lower buttons are conditionals. They have two presets: Preset scene 1 will have zones 1 and 2 go to 100%. Preset scene 2 will have zones 3 and 4 go to 100%. On the raise button, if the variable is at scene 1, we raise preset scene 1. If the variable is at scene 2, we raise the scene 2 preset. On the release tab of the button, both presets scene 1 and scene 2 stop. In order to properly operate the button, you need to send a press to start raising (“,3”) and a lower to stop raising (“,4”). The lower button is the same, it just lowers the presets.
    Attached Files Attached Files

Similar Threads

  1. WCI Raise or Lower Scene with a Hold
    By Armando B. in forum Programming - HWQS
    Replies: 10
    Last Post: 02-10-2022, 04:52 PM
  2. Momentary button like Raise & Lower...
    By whdigital in forum Programming - HWQS
    Replies: 1
    Last Post: 10-20-2014, 02:06 PM
  3. Raise or Lower on Last Button Double-Tapped
    By thomod in forum General Discussion - RA2
    Replies: 2
    Last Post: 09-02-2014, 12:57 PM
  4. Trying to raise and lower fixtures just programmed to that button
    By yaniquevirgo in forum Troubleshooting - RA2
    Replies: 1
    Last Post: 07-31-2014, 02:50 PM
  5. Master Raise/Lower Time
    By domino in forum Programming - HWQS
    Replies: 1
    Last Post: 11-18-2013, 08:29 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •