Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2

Thread: Minimum cool set point

  1. #1
    Junior Member
    Join Date
    Jul 2014
    Posts
    3

    Minimum cool set point

    Hi!!


    I have a HVAC controller with a seeTemp keypad and a wireless temperature sensor and the problem that i have is if i set the cool set point to low the compressor freezes and stop working, is there a posibiliti that i adjust the minimun cool set point??




    thanks

  2. #2
    Authorized Lutron Contributor
    Join Date
    May 2013
    Posts
    513
    Unfortunately, there is not a way to put a floor on the cool setpoint. With the 8.1.0 version of the HomeWorks QS software, you can use temperature sensor programming to your advantage. You can configure a temperature state where you would consider "too cold". Then, under the "Program->Sensors" tab, you can program so the cool setpoint changes and the system calls for heat. For more information on sensor programming, please see the attached app note.
    Attached Files Attached Files

Similar Threads

  1. Triathlon Roller Minimum Width
    By Armando B. in forum Design Assistance - Shades
    Replies: 1
    Last Post: 05-09-2014, 02:18 PM
  2. Minimum Loads for HWQS Devices
    By Armando B. in forum General Discussion - HWQS
    Replies: 2
    Last Post: 10-09-2013, 11:33 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •