Thanks Thanks:  0
Likes Likes:  0
Results 1 to 4 of 4

Thread: Crestron RadioRa2 Keypad Monitor feedback doesn't work

  1. #1
    Junior Member
    Join Date
    Jan 2015
    Posts
    2

    Crestron RadioRa2 Keypad Monitor feedback doesn't work

    I have a client that was wanting to integrate RadioRa2 to their table top keypads to allow for the security system to be armed in stay mode. I was wanting to use the button press pulse digital signal in the Tabletop seeTouch Keypad Monitor r05 to do the triggering. After testing the demo program that can can be downloaded on the drivers page, I've come up with the conclusion that there might be an issue with the Feedback Processing module in the Crestron module. I'm able to verify with Simple Debugger that the Feedback Processor shows serial response but does not feed out any high or low digtial signals like it should.

    I was was wanting to see if someone else can verify they are having the same issues with this module. Or has anybody found a way to make this work.


  2. #2
    Junior Member
    Join Date
    Jan 2015
    Posts
    1
    We are also having this issue, using RadioRa2 Inclusive V8.0 and Crestron.

  3. #3
    Senior Member
    Join Date
    Jun 2013
    Posts
    1,365
    I had issues with the iPad app feedback on 8.0. Upgraded to 8.1 and the newest iOS and the issue resolved itself. There are other threads on poor feedback from 8.0. Try a firmware update.
    Simple automation when DIY isn't working
    intuitivehomecontrols@gmail.com
    fb.me/intuitivehomecontrols

  4. #4
    Senior Member
    Join Date
    Oct 2013
    Posts
    247
    Is the general consensuses on 8.1 that's it's stable and safe?

    Been sticking with 7.8 until I get comfortable and give it a shot.

Similar Threads

  1. Crestron shade control
    By PACHAWAII in forum 3rd-party Integration - HWQS
    Replies: 2
    Last Post: 05-08-2015, 12:48 PM
  2. VPN access - Doesn't work !?
    By mehuneau in forum General Discussion - HWQS
    Replies: 1
    Last Post: 12-23-2014, 05:36 PM
  3. Adding a keypad to RadioRa2 system - electrical requirements?
    By geofry in forum Design Assistance - RA2
    Replies: 5
    Last Post: 09-30-2014, 05:38 PM
  4. How to Integrated the HWQS with Crestron ?
    By stevi in forum General Discussion - HWQS
    Replies: 5
    Last Post: 06-01-2014, 10:02 PM
  5. MACL dimmer doesn't work
    By Josh B. in forum General Discussion - Controls
    Replies: 2
    Last Post: 05-10-2013, 02:40 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •