I have a client that was wanting to integrate RadioRa2 to their table top keypads to allow for the security system to be armed in stay mode. I was wanting to use the button press pulse digital signal in the Tabletop seeTouch Keypad Monitor r05 to do the triggering. After testing the demo program that can can be downloaded on the drivers page, I've come up with the conclusion that there might be an issue with the Feedback Processing module in the Crestron module. I'm able to verify with Simple Debugger that the Feedback Processor shows serial response but does not feed out any high or low digtial signals like it should.
I was was wanting to see if someone else can verify they are having the same issues with this module. Or has anybody found a way to make this work.