Diagnostics in PC software?
What is the diagnostics mode showing, exactly? Is there any documentation on it?
When I bring it up on a two repeater (Inclusive) system there's a number of devices that intermittently appear/disappear from the list (with "[x] Show issues only" checked). Eventually, after 5 minutes or so, it seems to settle down. That is, it stabilizes on a list of devices 'with issues' but it's not always been the same devices.
None of the devices doing this have been having any kind of trouble operating. They've all reliably taken their Transfer from the program.
Does diagnostics favor one repeater over the other? Is there a way to select which one gets used for the purpose?
I've also noticed the repeaters don't always return to normal mode when the program exits diagnostic mode. The repeater continues to beep on device activities. Sometimes going back into Diagnostic mode (in Inclusive) and exiting again solves this, sometimes not. Then it takes sending a #RESET,0 or hard-power cycling it. This is somewhat repeatable. Use 9.3 Inclusive to enter diagnostics. Leave it there for 5+ minutes. Then use the [Done] button to exit. The repeaters won't show the "Exited RF Diagnostics mode on Link #0 @Time" line. Go back into diagnostics, let it show the list and then use the Done button to leave it again. This seems to properly exit both repeaters.