Help with Dimmer & 3 Way Switch
Hello, I have been going through my new home installing Caseta Wireless switches. I've had no problem with any other setups, including a couple other 3 way setups. But, I'm running into an issue with one particular set of lights. In my kitchen, I have some can lights that were on a 3-way switch. They have traditional rocker switches. On one side is a 2 gang set of switches - 1 switch for the can lights and 1 for an outdoor light. The switch on this side has 1 red, 1 white, 1 black, and 1 ground wire. They are each connected to individual terminals on the switch. On the other side of this switch is another rocker on a 4 gang set of switches. This switch has 4 wires also: 1 red, 1 white and red stripe, 1 black, and 1 ground. I'm attempting to install a Caseta dimmer switch with a remove to replace this 3-way switch. I tried doing the setup as it describes in the manual, but am not having any luck. The lights either don't work at all, or are permanently on. I tried putting in an old school dimmer in place of one of the rocker switches with the other side of the switch having the black, red, and white wires capped off together and the ground capped off, but that just resulted in the lights dimming, but staying on at all times. I should note that I have more can lights of the same kind: Halo ML706830, working with Caseta dimmers just fine. Any help would be much appreciated.