Old Homework’s interactive
My system was installed in 2002 and I purchased
My home In 2006. My system is basic with only lights and fan controls. I replaced some incandescent CBR 30 s with CFL R 30 dimmable
Over last 10 years with no problems as they were
Compatible. CFL s are getting scarce so I started replacing with dimmable led s made lay Sunco
Now they want stay on but 5 minutes or so and go off and I have to keep turning them back on
In an effort to overcome this I replaced all my kitchen bulbs with original incandescents but they
Still go off after 5 minutes. I have 6 Sunco dimmable leds in my pantry and they stay on with no problem. My lutron touch pads are HWI-KP-LB6 and the kitchen circuit is back to back with the pantry circuit. I interchanged the touch pads and kitchen circuit still goes off after 5 minutes but the pantry stays on so the touch pads are ok.
This leaves the problem in my control modules in the basement utilities room.
I reinstalled my staircase lamps with incandescent and they also only stay on around 5 minutes or so then go off
I have 28 drivers including two fan drivers.
There’s 7 drivers in each module cabinet.
My HWI-MI -120 processor is located in cabinet
Module one and has a manual over switch.
I can hit the override switch and every light in the entire house comes on and stays on.
When I turn on a circuit with the Sunco led R 30 s
The bulbs make a crinkle noise as they heat up then go off after 5 minutes.
My garage touchpad circuit has 18 double 4 foot
flouresent strips and they all stay on with no problems. I have touch pad controled flouresent strips under my kitchen cabinets that have no problems
It’s impossible to convert my home to standard 120 volt switches
Does anyone have any trouble shooting I can perform.
Old Homework’s interactive
I just purchase 16 HD-RPM-4 U 120 used modules but came out of a working system
I thinking maybe my modules are damaged by the
Led bulbs so I plan to swap the kitchen module
To see if the kitchen circuit stays on
I was instructed to match the address dial number
(1 through 6) with the modules I am replacing
I have already switched the kitchen lights back to
Incandescents that still only stay on 5 minutes or so
If this doesn’t work i can hopefully eliminate the modules as being the problem
You mentioned the vacation mode could be the problem.
How do I check and reset the vacation mode
Also the pantry leds that stays on are on their own 15 amp breaker and maybe not wired to a module
I have basic electrical knowledge so some of these issues are over my head
I also swapped my staircase led s back to incandescent (6) and they still only stay on about 5 minutes
I have two rooms that have MR 16 halogen ( 12) in valances that stay on with no problem
I am open to any suggestions to fix my problems
Thanks
My cell phone is 239 872 6950