-
Minimum cool set point
Hi!!
I have a HVAC controller with a seeTemp keypad and a wireless temperature sensor and the problem that i have is if i set the cool set point to low the compressor freezes and stop working, is there a posibiliti that i adjust the minimun cool set point??
thanks
-
1 Attachment(s)
Unfortunately, there is not a way to put a floor on the cool setpoint. With the 8.1.0 version of the HomeWorks QS software, you can use temperature sensor programming to your advantage. You can configure a temperature state where you would consider "too cold". Then, under the "Program->Sensors" tab, you can program so the cool setpoint changes and the system calls for heat. For more information on sensor programming, please see the attached app note.