Pico > PowPak > Repeater?

After a few calls to support, hopefully someone here can help me.I have a PowPak controlling lighting for 16 rooms, and a Pico remote controlling the PowPak.

There are 6 setups like this and 4 work reliably.

The problem is 2 of the PowPaks are on the outer border for range from the Pico remote.

-The PowPak seems to be compatible with RA2 Select.

-RA2 Select seems to be compatible with a L-REPPRO repeater.

-Pico remote seems to be compatible with both.

Can I simply pair the Pico to the new L-REPPRO repeater, to have it re-broadcast the remote's signal?

What's the best way to set up a system (if possible)?

Caveat: There is no internet.

Thanks

Hello Phaiz,Depending on which PowPak controls you have will determine if they are compatible with any Repeaters. You would need to be using the models that begin with LMJ-. These PowPaks will work with the Ra2 Select Main Repeater which is model RR-SEL-REP2-BL. The L-REPPRO is an Aux Repeater that will extend the coverage of the Main Repeater and could be used if needed, but will not work by itself.

Phaiz- if you do this, make sure to plug the repeater into a live internet connection for about 15-20 minutes. This should give the repeater time to download any necessary firmware updates. Then you can take it to the job site and program using the contractor mode.