DALI Load type problem

I don't know if anyone has spotted this,

When you make a DALI LED fixture and you set the low end level to 1%.

When you go to add a circuit or load with that load type it comes back with a Low end of 10%

Annoying !!

Any ideas !!

Thanks

PS I am using 7.4 or 8.1 with the same effect.

Edit fixtures/dimming range
Set to 1% and then you can change the low end
This worked for me on 8.1. Haven't tried it on 7.x though

Quote:

---

Originally Posted by LightBrigade

Edit fixtures/dimming range
Set to 1% and then you can change the low end
This worked for me on 8.1. Haven't tried it on 7.x though

---

Tried what you did on 7.4 and 8.1
It did not work.
I made a new fixture, set the low end to 1% and the Dimmer range to 1%.
Then went to the load page.
entered a new load with the new fixture type that the low end reads 10% !!!!!

Thank you for this feedback; we are able to reproduce this and will work with our software team to fix it in a future release.

Sorry abutchart - looks like you found an issue! Not sure why it isn't consistent though?!