3rd party occupancy sensors

AFAIK the only way to integrate 3rd party sensors into a HWQS program is to wire them to a QSE-IO.

On the other hand the most convenient way is more than often to wire these to CCI inputs on a keypad.



On a related subject, being able to copy and paste CCI programming would save me A LOT of time. Programming conditional stuff on these and not being to copy it to the next one is a PAIN.

Quote:

---

Originally Posted by mehuneau

AFAIK the only way to integrate 3rd party sensors into a HWQS program is to wire them to a QSE-IO.

On the other hand the most convenient way is more than often to wire these to CCI inputs on a keypad.



On a related subject, being able to copy and paste CCI programming would save me A LOT of time. Programming conditional stuff on these and not being to copy it to the next one is a PAIN.

---

mehuneau,

You are able to use a third party sensor on the CCI inputs on a wired keypad. The sensor must be a dry contact closure.

You will need to program the CCI state changes (Open/Close) in the HomeWorks QS software to reflect the occupancy and vacancy states of the sensor.

Yep, my point exactly. That can't be programmed in the Occupancy tab.

Quote:

---

Originally Posted by mehuneau

Yep, my point exactly. That can't be programmed in the Occupancy tab.

---

mehuneau,

Currently, you cannot use the Occupancy tab.

Thank you for the feedback. I will pass this feedback along to our development team as a feature request.