Hi
I'm designing a lutron program for a system with Dali relays, does anyone know which load type to use?
That I can see I have the option of Dali florescent or Dali LED ?
Thanks
Sean
Printable View
Hi
I'm designing a lutron program for a system with Dali relays, does anyone know which load type to use?
That I can see I have the option of Dali florescent or Dali LED ?
Thanks
Sean
Hi Sean
I'm still waiting for an answer to this question from April last year
Andrew
Hi Andrew.
I guess its one of those tricky grey areas!
Sean
what. Wanting a DALI switched circuit.
It cannot be that difficult if people make relays.
All I can see is being the problem is the assigning setup as the dali driver will need to go between highend and lowend but not off
Hi
Hmm. Sorry for my flippant answer!
The problem will be the lutron systems recognition of the dali relay device descriptors, how it maps them to its internal representation of loads, modules etc. I'm guessing they have not done that yet. You would imagine it to be easy, but any change in design software and embedded firmware would take time, mainly regression testing. I presume there is not a big demand or perhaps they are encouraging the use of their switch modules.
Anyway I am guessing. It would be nice to get an answer of some sort to the dali relay question.
Sean
Hello all,
Thank you for your patience while I confirmed with engineering on the question.
Non dimmed DALI loads are not currently supported. We will keep this feedback for future consideration.