-
Cree LED Low End Trim
I have Cree LED bulbs, and a scene setup with RRD-6NA dimmers, the scene sets the dim level to 1%, of course not all of the banks of lights come on.
However, if I turn them to full on and then to 1% it works fine (with no flicker).
I’ve also repeated the test with 5%, and the same effect.
Repeating with 10% works, however, it is significantly brighter than 1% or 5%.
Any suggestion?
-
I don't know what bulb you are using but the LED Report Card tool only lists 1 Cree fixture that will go to 1%. There are a couple that go to 5%. Lutron probably lists higher low ends to avoid the issues you are describing.
-
SRDL6 and SRDL4 which I can’t find the report card for, but they work fine all the way down to 1%
The circuit I have a problem with though has 2 SRDL6 bulbs, and two A19 bulbs (http://www.lutron.com/en-US/Resource...%20REV%20B.pdf) it looks like the A19 only support 9% so I guess that’s where my issue is, probably makes sense to trim all the ones in that floor at 9% until I can potentially replace that fixture with a downlight, although I wish there was a report card for the downlights.
Is there a better A19 bulb to use?
-
You didn't mention it, so I'm just confirming. Did you set the low end trim properly on each of the individual RRD-6NA dimmers?