MS-OPS5M companion switch acts as "master"
I installed a MS-OPS5M in a 3-way circuit. The companion switch is a standard new on/off 3-way. I used the yellow jumper wire per instructions for the companion.
When I restored power, the sensor switch functioned correctly. The companion did not, and per the instructions I swapped the travelers. The companion then functioned closer to correctly, but now acts as a "master switch": when the companion is "off", the sensor switch does nothing. Only when the companion is "on" does the sensor function normally.
My expectation is that regardless of the companion switch position, the sensor should turn lights on when it detects motion - after suitable time interval, etc.
Does anybody have an insight into how I can wire the companion correctly so that it's a "companion" and not a "master"?
-- Bill