Controlling dimmer's dimmed position manually

Hi guys,

This probably has been discussed before. If this is in the FAQ please let me know.

When a dimmer is just installed and not part of the radioRA2 programming we can set the dimmed position manually at any time and that setting would be retained until we change it again.
Once it is programmed then I noticed that we can't set the dimmed position manually anymore, it is always back to the "specific dimmed position" that I am not sure from where.

So then the questions I have:
1. Is there a way to be able to control the dimmed position manually once it is part of the programming?
2. Where do you set that dimmed position for a dimmer once it is part of the programming? If it is based on the last scene then it is kind of bad because that would change all the times depending on the last scene used.

Thanks all.

I found the answer to question #2. It is set in the Advanced settings window (Design tab, right-click on dimmer). Will try this soon.

If the "On Level" is set to a level then there is not away to locally change this level. If the "On Level" is set to be the last level then the light will turn on the last level the dimmer was set to locally.

Ok. Thanks Craig.