PD-5ANS only seems to work corectly with one LED bulb
I have two different sets of lights I am trying to control
- Set 1 - Garage
- 2 bulbs - 60W LED (not equivalent, 60W each) https://smile.amazon.com/gp/product/...?ie=UTF8&psc=1
- 3 way switch
- Location 1 is the PD-5ANS
- Location 2 is the Pico remote. so the runners and load are tied together. (get same behavior if I wire in the switch at location 2)
One bulb in the outlet works fine. With two bulbs it works for a few minutes and then stops. At that point I have to remove power to the switch and it starts to work again until it doesn't
I like these bulbs a lot and will forgo the Caseta switches to use them if I have to.
Again, one bulb in the outlet works fine. With two or more bulbs it works for one or two cycles and then stops. At that point I have to remove power to the switch and it starts to work again until it doesn't
In both cases I have the switch wired as follows: - Location 1:
- Green - Ground
- Blue - capped off
- White - to neutral/return
- Red - to "main" (the one you put the tape on)
- Black - to the red and black runners to location 2
- Location 2: Runners and "main" twisted together Ground capped off
Any help/correction would be greatly appreciated.
Different bulbs worked Outside
Okay. I replaced the 4 outside lights https://www.poweredbyefi.org/masssav...-incented.html with 4 Amazon type A 14W https://smile.amazon.com/gp/product/...?ie=UTF8&psc=1 and they seem to be working fine. Ugly, but fine.
I could not find a compatibility list for this switch type.Only for the dimmers. Will keep looking
It's a shame about the garage lights https://smile.amazon.com/gp/product/...?ie=UTF8&psc=1. I will have to put the old light switches back because those lights are amazing.