Lutron Caseta Dimmer Not Working
I've recently purchased my third Caseta dimmer, and upon install, found it's not working.
I'm trying to replace a Lutron Diva CL I believe it is? It's a Lutron dimmer, large padle switch, with the little slide next to it for dimming. Upon removal, I found it had been wired with a hot/load/neutral/ground configuration. (http://www.lutron.com/TechnicalDocum...93_Page_38.pdf)
I took the switch out & capped the neutral, connected the hot & load lines to the dimmer, and connected the ground. Upon making contact with the second black wire, the lights (LEDs) in the room began to glow, but the switch was not functional. I couldn't turn the lights on or off, or even get an LED response out of the switch while it was wired in. Is there something I'm missing? Do I have a bad dimmer, or is something else going on?
Trying to replace Diva with Casetta
I am trying to replace a Lutron Diva DVELV-303p with a Casetta in Wall dimmer.
I have tied off three wires at one end (per instructions).
At the Diva end I have four wires (see photo below). They are Wall Black to Diva Yellow, Wall white 1 to Diva Red/white, Wall white 2 to Diva White, and wall red to Diva red.
I cannot figure out how to connect this array of wires to the Casetta dimmer.
I have installed a dozen Casetta dimmers without problems. This one is stumping me. Please help by responding to this email.
Thanks.
Sent from my iPad