Programming Error

Hey there, I am programming my first system and I keep getting the error "Only loads with same feed can be assigned to a device"?? I am trying to recreate the programming from the previous Interactive system and going by the load printout from 13 years ago, I am trying to assign the same loads to the same slot on the RPM?

If you input a number in the "feed" column for a load it must match the other "feed" columns of loads you intend to put on the same device when you assign circuits.

I'm not 100% sure, but I think its because on phase adaptive dimming units for example, they can only have one "feed" powering them, therefore multiple different feeds isn't possible.

Hope that helps.

Ash

Quote:

---

Originally Posted by Brand

If you input a number in the "feed" column for a load it must match the other "feed" columns of loads you intend to put on the same device when you assign circuits.

I'm not 100% sure, but I think its because on phase adaptive dimming units for example, they can only have one "feed" powering them, therefore multiple different feeds isn't possible.

Hope that helps.

Ash

---

Thank you very much. That was the mistake.