Are there any special settings to control 1-10V ballasts with the LQSE-4T10-D?
thx
Werner
Printable View
Are there any special settings to control 1-10V ballasts with the LQSE-4T10-D?
thx
Werner
Hello wzelinka,
I am unaware of anything special required. Although the specification sheet does call out 0-10v rated and not 1-10v. I assume that this fixture you are controlling has nothing defined between 0-1v and may not guarantee the fixture will shut off solely from the low voltage control. That shouldn't be a concern anyhow since the LQSE-4T10-D also controls the fixture on the line voltage side. The only adjustment I am thinking you may need to make is a low end trim adjustment if you experience some dead travel at low end.
thanks for your reply
Werner