Printable View
I have a circuit that intermittently turns on by itself. The LED next to the pad is NOT lit. If I go to the HWI software it does not show it as on. I tried rebooting the processor via software and that didn't change anything. I tried an "All-OFF" button that I'd programmed into my system and that DID turn off the circuit, and now it works normally. ... Until the next time!
Any thoughts?
Hello DHKaplan,
Thank you for your post.
What is the load type? What is the dimming control? Perhaps they are not compatible and this is the reason for the issue.
The load is a transformer feeding a 12V cable light system. The "dimmer control" is the standard Homeworks module in the electrical panel. This has worked fine for over 10 years and is now acting up.
What is the load type on the low voltage side of the transformer?
Low voltage load is 20w halogen MR16....
I would swap with a known good RPM to see if the issue follows.
Hi all.
I want to bring up an old topic because I have a similar problem.
An area consisting of 3x10W 220V LED lamps is connected to a dimmer HW-RPM-4U-230-CE.
Switching on occurs by a presence sensor or by pressing a button on the wall panel.
The lighting periodically turns on and off spontaneously.
Changed the presence sensor. Changed the dimmer. The situation has not changed.
What could be the problem?
Thank you in advance for your help.