I wanted ti ask if it's possible to set the default state of a switch such that if there is a power loss, etc. that the switch goes back to its default state. Or does the repeater remember the last known state?
Printable View
I wanted ti ask if it's possible to set the default state of a switch such that if there is a power loss, etc. that the switch goes back to its default state. Or does the repeater remember the last known state?
Hello!
Yes, the unit will automatically restore its last known state.
If the dimmer/switch can communicate with the Main Repeater, it will go to the last known state from the system.
If the dimmer/switch cannot communicate with the Main Repeater, it will go to it's On Level value. The On Level value can be programmed in the RadioRA 2 software by going to the Design tab, right-clicking the device, and selecting Advanced Settings. The default On Level is "75%". If you choose an On Level of "Last Level", then the device will restore to whatever the last value was.
Thank you.