Caseta dimmer PRO with TuWire dimming ballast : when turned off, turns back on
I installed a Caseta In-Wall dimmer PRO PD-10NXD to replace an appropriate Diva dimmer for a
Tu Wire ballast, 2 T8 4' fluorescent fixture. Previously worked like a charm.
I very carefully reviewed the tech doc before going ahead, and it is listed as compatible, no neutral required.
I works fine (adjusted with trims) except that when I push the "off" button it turn off but after 1-5 seconds will automatically turn back on, at a low level. I can recreate within the iOS app, when turned off, then adjusting to 1% it turns off, then back on, then adjusting to 2% it turn off again, then back on.
It's been like that for a couple of weeks. I found the LUT-MLC used by the switches for low loads and wonder if it would work.