Where is the HWQS monitoring output?

Printable View

08-15-2018, 01:04 PM
ElPatricio

Where is the HWQS monitoring output?

I just had a HWQS system installed and I turned on event monitoring via telnet so I could find the integration IDs for all my components. Where is the output of the monitoring? Events don't appear to be displaying in my telnet session when I change dimming on some lights. Here's the session showing the event monitoring setting:

QNET> #MONITORING,2,1
~MONITORING,2,1
QNET> ?MONITORING,255
~MONITORING,1,2
~MONITORING,2,1
~MONITORING,3,2
~MONITORING,4,2
~MONITORING,5,2
~MONITORING,6,2
~MONITORING,7,2
~MONITORING,8,2
~MONITORING,9,2
~MONITORING,10,2
~MONITORING,11,1
~MONITORING,12,1
~MONITORING,13,2
~MONITORING,14,2
~MONITORING,16,2
~MONITORING,17,2
~MONITORING,18,2
~MONITORING,19,2
~MONITORING,20,2
~MONITORING,21,2
~MONITORING,22,2
~MONITORING,23,2
~MONITORING,24,2
~MONITORING,25,2
~MONITORING,26,2
~MONITORING,27,2
08-15-2018, 01:26 PM
ElPatricio

Ok, I turned on some more monitors and I'm getting some output in my telnet session, but the event monitoring output does not show the integration id of the device associated with the event.

Also, where is the documentation on the messages from the monitoring? For example, I see a "GLINK_INFO_DUMP for HWQS-KEYPAD-DOM2 Object ID 00000400" message. Without output documentation, I'm not clear on what that message means.
08-17-2018, 06:48 AM
Craig W.

The integration protocol guide can be found at http://www.lutron.com/TechnicalDocum...ary/040249.pdf. As for the "GLINK_INFO_DUMP for HWQS-KEYPAD-DOM2 Object ID 00000400" message this is not used for integration. This message indicates the the devices was sent information from the processor.