I have a project that I had some issues with last night
I have 5 processors 10 rpm panels and few hundred RF devices. This project is still in its begging stages but for the last year the system has been up and running fine. Yesterday I tried to add MI's for 2 RPM panels. RPM 9 and MY RPM 10 but those address are 0 and 1 they are on there own link so they're not 9 and A
Obviously I checked the usual stuff the rpm's sit on there own link and processor. I can talk to the processor just fine.Link type is set proper, wiring is proper and addressing is fine. For the love of god I can't get this one processor to talk to 2 MI's. The led status of the MI's are Heartbeat Led fine,Processor communication led is fine I have no Module communication LED. So far I have switched the processor power panel link to the processor next to it with no luck. I have switched addressing on MI and re uploaded I have done everything that normally should be checked. I remember in some early versions of QS my processors would go into a loop and I would need to switch link types and make a dummy project and re upload. Once I did that I was able to upload the original project and system would come back. I thought that was resolved in 6.x or possibly Rev 7. I will try that method this morning to see if I can get those 2 stubborn MI's to talk. I was weary of this because it would mean I have 2 looped processors and the rest of the system is fine but the 2 processors I am referring to currently control nothing yet so I wouldn't notice stuff not working.
Any suggestions would be helpful