Just installed a W6BRL. The top button is meant to control a table lamp (attached to a 3PD-1 plug-in dimmer). I programmed the button as Toggle Control/ Room monitoring.
- First press turns the lamp on. LED is lit for about 1 second and then turns off
- Next press… nothing happens
- A double-tap on that 1st button turns the lamp off (I didn’t think you could double-tap a keypad button.)
I then programmed all 6 buttons as above. Button 2-6 act as I expected. 1st press on; 2nd press off.
Thought maybe it was a bad keypad so I swapped it out with another W6BRL. Same results!
What am I missing?