Printable View
I am looking to have a ceiling motion sensor that is manually paired with a Maestro Wireless elv dimmer turn the lights on at a preset level. At this moment when the wireless ceiling motion sensor trips the lights go on to full. How do i save the settings so the motion sensor turns the lights on at a preset level? Thanks for the help!
I'm not 100% sure it will work but you can program the MRF dimmer turn on a preset level. It would depend if the sensor sends an "on" command or a "100%" command.
Hi AustinB.
Thank you for your post! If you are using our Radio Powr Savr battery powered Occupancy Sensors like an LRF2-OCR2B-P-WH, you can set up a the occupancy sensor to turn the lights to a preset light level by doing the following:
1.) Manually set the light level on the Maestro Wireless ELV dimmer using the up/down butons.
2.) On the LRF2 Occupancy sensor, press and hold the light bulb button in for 5-6 seconds until the sensor lens starts to flash on/off and then release.
The LRF2 Sensor will now turn the lighting load on to the preset light level when motion is detected with the lighting load off.
Hope this info helps!
-JustinF.
Hi Justin, When I do your steps it appears to initialize correctly, but the sensor continues to turn the lights on at 100%.
I have an LRF2-OCR2B-P-WH sensor, Radio RA2 dimmer (RRD-PRO-LA), and a RadioRA2 Select controller.
I set the preferred lighting level using up/down buttons.
Pressing the dimmer button for 6 seconds causes all LEDs to blink.
Pressing and holding the Light button on the sensor for 5-6 seconds causes the sensor light to blink several times and then stop.
The Light button on the sensor then turns the lights on and off at 100%.
The dimmer is not connected to the RA2 Select controller.
I called tech support before I installed the sensor to confirm that it was compatible with the RA2 dimmers, but still not sure.
Advice?
Thanks