How to use 0-10V dimmer with RA2 Select
I have an LED strip fixture and power supply from PureEdge Lighting that is controlled by a Lutron RRD-6NA dimmer. Unlike the many other LED fixtures/power supplies in my house controlled by the same type of dimmer, this one randomly goes out sometimes. It doesn’t trip the breaker—the light just goes out, even though the dimmer is still powered. Turning the dimmer switch off and on turns the light back on. Replacing hardware and extensive troubleshooting with PureEdge customer support, my electrician, and elsewhere has not resolved the problem, and has led to the hypothesis that a 0-10v dimmer might solve it. I see that the only Lutron dimmer for RA2 Select is the LMJ-5T-DV-B. But it’s not obvious to me how it is used. Is it installed somewhere in addition to my RRD-6NA wall control? Or would I install it and also replace the RRD-6NA with some other kind of wall control? Thanks!