RRD-6NA flickering led strip woes.
I've got an LED under-counter strip that has had major flicker problems since it was installed. There are only a few "sweet spots" on the RRD-6NA dimmer where it won't flicker.
Tried swapping out the driver/transformer with two different brand new units. No change.
Swapped out the 6NA dimmer with a brand new one. Manually tested it and the flicker was gone! Problem solved, I thought.
Fired up the RadioRA software to activate and transfer the new switch to the Main Repeater. Transfer went smoothly, but the flicker was back!
I used the triple-tap method to factory reset the new 6NA, and sure enough, the flicker is gone again. As long as the dimmer is not part RR2 network, it works perfectly fine.
Any ideas?
Thanks!
AC LED strip & Maestro Pro
Hi All!
I have an AC LED strip that inherently flickers with line voltage frequency and is marketed as being TRIAC dimmable. I’d like to reduce the flicker effect and am hoping to use a Maestro Pro dimmer to do so. Given that it’s listed as dimmable via TRIAC (which is typically forward phase), will reverse phase work on it? If so, and it reduces the flicker effect, will it only do so below 100% when, in theory, dimming is in effect?
Thanks so much!,
Chuck