Set Plug In Dimming Module to Switching Mode?

Hi folks,

While browsing the documentation of the dimming module:
http://www.lutron.com/TechnicalDocum...es_English.pdf

There are several mentions of setting the dimming module to switching mode for loads that don't support dimming. How does one do that? I glossed over the doc and didn't see any info on that. Thanks!

Here is the link to the Advanced Programming Guide, this will guide you through setting the plug in dimmer as a switch only.

http://www.lutron.com/TechnicalDocum...ary/048247.pdf

Thanks Mike! I don't see the Dimming Module / Switching module in that document, just in-wall switches...?

What is the model of the module you have, it should fall under the dimmer section. You would just need to use the Secondary Programming menu on Page 3.

Actually, I was referring to the RR-3PD-1 (spec sheet in my first post) :)

http://www.lutron.com/TechnicalDocum...es_English.pdf

On the bottom of Page 2 of the spec sheet (RR-3PD-1 column) it says "Control non-dimmable lighting loads in switching mode"...

There is an option in Essentials under the design tab, select load type. There are 8 choices, some are dim-able and others non-dim-able.

Eric

So I can just choose the non-dimmable option in the programming software even though the RR-3PD-1 is dimmable?