Control4 and QS Standalone Shade System via HouseLogix driver

Looking for some help!

Current Setup:
Control4 System on v2.8.0 (HC800 Director)
(9) QS hardwired Standalone shades
(1) Lutron QSE-CI-NWK device on Firmware v8.60
(1) Lutron back up keypad for raise/lower

via putty I have assigned Integration IDs as following:
Shade panel: "01"
QSE-CI-NWK: "02"
Master Bedroom Shade 1: 03
Master Bedroom Shade 2: 04
Grand Shade 1: 05
Grand Shade 2: 06
Grand Shade 3: 07
Grand Shade 4: 08
Grand Shade 5: 09
Kitchen Shade: 10
Library Shade: 11

-Prior to assigning IDs I factory rest all the shades and keypad. I do not know how to factory reset the shade panel (could not find directions) so this is as was.
-I put static IP on the QSE NWK
-I've installed the Houselogix standalone driver into Control4
-Added the shades drivers and confirmed they are bond in connection to the QSE NWK driver.
-Added the ID to the drivers assigned above
-I've added the ID and password to the QSE-CI-NWK driver within Control4. O2 NWK
-Control4 appears to be communicating with the QSE-NWK as I get feedback in the "lua" tab when setting "debug" to print and log.
-When sending open/close from the driver the shades do not work.
-All shades go open/close from panel and keypad without issues.

I'm guessing I'm missing a key step that is not allowing control. Or the integration IDs need to be a certain way. Thoughts? Ideas? Please help. I have 30 of these I need to integrate! Yikes!

Hello Bethesda Jason,
What you will want to do to correct the issue is use action 4 when setting the integration ids. You will notice that the parameters ask for a component number. This will need to be set to 0 for shades. After this is complete the #output commands Control4 wants to send will work.

Blair,

Thanks for helping! "Action 4" does not seem to be an option for integration id. Where should I see the "parameters" that ask for component? within telnet? Do you have an example of the action 4 that will correct this. I can seem to find anyone within Lutron or HouseLogix that can help me, as of yet at least.

Thanks!

Apologies. I thought you were referencing our integration protocol. I have included a link, check out page 20.
http://www.lutron.com/TechnicalDocum...ary/040249.pdf

Blair, I figured it out! Thank you for pointing me in the right direction.

I think the Control4 driver documentation could be a bit clearer on having to set a component ID to each output but that would be up to Houselogix I guess.

Hey Jason,

I'm having the exact same problem now with a 2.10 Control4 system. I have set this up a few times on 2.91 and those still work. I'm wondering if I forgot something (like you discovered) or did 2.10 break the driver.

Any help would be appreciated!

Steve