Printable View
Whats the best way to rough in for a LR-TEMP-FLSH? I see they want a 1/2" hole in the drywall, however if I have my wire stubbed there is no way the drywaller will make the right size hole and then it'd be (difficult) impossible to drill a 1/2" hole with the wire there. Any suggestions would be appreciated! I've seen them installed in single gangs, but I'd like to make it as invisible as possible.
Thanks
Colin
Lace the wire in the wall and fish it out after sheetrock. If you wanted to mark the spot you could stub a scrap piece of wire out.Quote:
Originally Posted by weekscolin
yeah, i'm just concerned with pulling a wire through a 1/2" hole without messing up the drywall a bit (i read the flush mount sensor is a bit temperamental) and with drywallers in our area if there is something stubbed out they tend to cut, eh, various size holes.Quote:
Originally Posted by randyc
1/2" isn't bad for fishing a cat 5. It's even easier if you use a smaller 2-conductor wire. You are probably going to have to touch up around the sensor either way.Quote:
Originally Posted by weekscolin
They suck! They don’t even screw in nicely, the resistive curve isn’t an exact match for the touch pro dimmers either.