For the life of me I cannot remember how to set up a keypad button to toggle the output of the VCRX to open/close a door. Everything is setup and running correctly I just cant remember the steps to program the outputs of the VCRX.
Thx.
Printable View
For the life of me I cannot remember how to set up a keypad button to toggle the output of the VCRX to open/close a door. Everything is setup and running correctly I just cant remember the steps to program the outputs of the VCRX.
Thx.
In design:loads you need to create a load and set the load type to one of the CCO options.
In design:equipment you need to assign that load to the proper output
You can now program it to a keypad button. For a garage door you are probably using CCO-pulsed so you will probably change the button to single action and the LED logic to "Momentary when pressed."