Difficulties Activating controls
Just getting a new system up and running. Had a keypad and a couple controllers set up. Went to add another controller today and couldn't get anything activated. So I did perhaps a foolish thing and pressed the reactivate all buttons. Of course now I can't activate anything. When i hit activate, after a few minutes, I get the pop up window stating that it has found the main repeater, but then it just sits there and nothing further happens. If I hit save and close, then it does a ping and is successful but it then shows the activation was cancelled. This was the issue I was getting when I was trying to add a new control device (thus I did the reactivate everything). I've turned off the repeater and restarted it after several minutes, I've checked all the connections and nothing. The repeater is connected via Ethernet into the modem and the controls are within 12 ft. (except for the keypad). The RF-WIRELESS-ADD-TEST flash green in a clockwise motion quickly.I noticed earlier that they were flashing in the manner but changing occasionally between red or green.