Verifing loads and devices in HomeWorks QS
Hi every one,
I have some troubles with verifing loads and devices when I did upload programming into processor, when I get verifing devices it apears a question´s signal on left tab from the device ( in this case the devices are wireless picos ) wich they don´t allow me to perform a verification; the question´s signal means that the device could not be tested. On the other hand, when I do a verification on the loads, these are not responding; only do the dimming plugins. In the process to activate all RF devices, whe I pushed the lower buttom of any pico, the software hears all of them in the link and when I activate the pico that was heard, the other picos does not activate.
I don´t know what to do because when I perform a verification in one dimming plug, all dimming plugs in the link respond at the same time.
Thanks in avance for your help.
Christhian Flores