0-10 Volt

Printable View

03-15-2016, 05:45 AM
cabethesda

0-10 Volt

I have a TVM Kit with several GRX-TVM2's installed and none of 0-10v zones are dimming. Everything seems to be good in programming, are there any recommended troubleshooting steps i can use to track down the issue? My 0-10v fixtures are identified in programming and I have the correct harness connectors attached to corresponding RMP's. Thanks for any input
Chris
03-15-2016, 09:49 AM
mcignarella

Yes

Simply check if there is voltage coming out of the 0-10 wires as you dim. You should see the the voltage change coming out of the TVM. The RPM are irrelevant to the 0-10 they are used to kill power to the driver in the case 0 is not true off Off course you need the 110 v power going to the driver so if that is on the RPM make sure there is 110 going to driver.
03-15-2016, 10:44 AM
cabethesda

Quote:

Originally Posted by mcignarella

Yes

Simply check if there is voltage coming out of the 0-10 wires as you dim. You should see the the voltage change coming out of the TVM. The RPM are irrelevant to the 0-10 they are used to kill power to the driver in the case 0 is not true off Off course you need the 110 v power going to the driver so if that is on the RPM make sure there is 110 going to driver.

Perfect, Thanks

All times are GMT -4. The time now is 09:39 PM.

This website may contain user-submitted content and is for informational use only. Lutron disclaims any and all liability for the accuracy and correctness of content and conduct of any third parties in connection with or related to your use of the site. Please see the Terms of Use for more information.