HRD Dimmer serial addressing problem
Hello all. Hoping someone might be able to help me out with a dimmer addressing issue. I recently added an HRP5-120 RF processor to my existing Illumination system. Have gotten everything setup and working except for some used HRD-6's & 5NE's that I picked up. They refuse to show up upon triple-tap in serial address mode. Have several new keypads and HRD's that came up with no problem, so this leads me to think that there is an RF reset procedure I'm not aware of?
I have tried the APM reset procedure (Switch FASS on while holding tap button until load dims twice). Have also found reference to a reset by triple-tap/hold, triple-tap again procedure but the dimmers do not respond to this with scrolling LED's.
Any suggestions would be appreciated!!