Activity Stream - Lutron Support Community

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

Yesterday, 04:43 PM

SparkyCoog started a thread allumé ,L'ecart, pré-réglage What's up with the newer See-Touch label stickers? in General Discussion - RA3

I've noticed this in the last few months with newer SeeTouch button labels, but what is going on with the new labels? I couldn't find simple labels...

1 replies | 21 view(s)

Yesterday, 03:04 PM

SparkyCoog started a thread VCRX trained visor control works on button but not on Homelink in Troubleshooting - RA2

Converted an old Radio Ra Classic system to Ra2 (Not Ra3 because I needed Wallbox Power Module support but I digress). The old system had the...

0 replies | 18 view(s)

Today, 09:18 AM

jdbnsn replied to a thread Can I power an RRD-W6BRL keypad from what used to be a 4 way switch? in Troubleshooting - RA2

Thank you. I actually figured it out last night. My neutrals in the 4way box were hot but there were other leads to tap into and now it's all good....

2 replies | 64 view(s)

Yesterday, 11:36 PM

Woodside Electric replied to a thread Wireless 3 way with a load on both sides in General Discussion - Controls

In Ra2, 2 Hybrid keypads would work. Although a bit expensive if there isn't an existing system.

3 replies | 166 view(s)

Yesterday, 11:23 PM

Woodside Electric replied to a thread Can I power an RRD-W6BRL keypad from what used to be a 4 way switch? in Troubleshooting - RA2

It should work. You are probably measuring the switch leg (brass screw) side of the 6CL. You need to find the switch box that has the actual switch...

2 replies | 64 view(s)

Yesterday, 11:01 PM

Woodside Electric replied to a thread allumé ,L'ecart, pré-réglage What's up with the newer See-Touch label stickers? in General Discussion - RA3

I find it easier to export the engraving report then cut them out and tape them horizontally next to the keypad. That way the customer can see...

1 replies | 21 view(s)

Yesterday, 12:43 PM

Pamella replied to a thread Cannot Connect to the System in General Discussion - HWQS

I have the same issue (can't loadystem) but you are talking over my head I think. I'm not understanding the processes you are suggesting. I'm using...

11 replies | 26737 view(s)

Yesterday, 11:52 AM

CJFountain replied to a thread Pd-6wcl doa? in Troubleshooting - CAS

Thanks! I thought that might be the case (the FASS does shut off the switches that are working). I'll confirm it--but it's not obvious where the...

5 replies | 88 view(s)