Activity Stream - Lutron Support Community

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

Yesterday, 07:47 PM

bdflood replied to a thread Diva Smart Dimmer on hallway with 6-way switch in General Discussion - CAS

I'm not an electrician but from what I can tell from page 26, it looks like I can use 5 Diva Accessory Switches with one Diva Smart Dimmer. I'll...

2 replies | 61 view(s)

Yesterday, 05:40 PM

mmascari replied to a thread Diva Smart Dimmer on hallway with 6-way switch in General Discussion - CAS

https://www.casetawireless.com/sites/g/files/fhphhs136/files/2022-12/369987_ENG.pdf Page 26. DVRF-6L and Smart Accessory Switches (DVRF-AS)

2 replies | 61 view(s)

Yesterday, 12:01 PM

Kyle L. replied to a thread Not finding what I need - help? in Design Assistance - CAS

Hello Eric. You can use a PD-5WS-DV which is a non-neutral based smart switch that is part of the Caseta line. This switch can be used with an...

1 replies | 101 view(s)

Yesterday, 11:33 AM

Bill13 replied to a thread Upgrading Ra2 to Ra3 - with Control 4 in Home in General Discussion - RA3

Thanks John. So, the upgrade changes the device id/href and also the button href? Oh well wish, that was not necessary! - - - Updated - - - ...

2 replies | 57 view(s)

Yesterday, 10:51 AM

Garrett S. replied to a thread LED 0-10V dimmer switch in Troubleshooting - Controls

Do you have the model number of the strip lights you are using? With 0-10v dimming, you can short the low voltage wires (should be purple and gray or...

1 replies | 102 view(s)

Yesterday, 10:33 AM

rahulkumbhar replied to a thread Setting up Lutron Connect app for the first time on RA2 system w/ Connect bridge in Best Practices - RA2

Very Nice Information Krnl open IV Beetv Apk

10 replies | 31527 view(s)

Yesterday, 10:23 AM

johnmax replied to a thread Upgrading Ra2 to Ra3 - with Control 4 in Home in General Discussion - RA3

Yes the C4 system will need programming changes.

2 replies | 57 view(s)

Yesterday, 08:57 AM

Garrett S. replied to a thread Maestro LED+ Full Brightness After Power Outage or Surge in Troubleshooting - Controls

Hi, Can you replicate this issue by turning the lights off then pulling the FASS (small tab below the tap button) then pushing the FASS back in?...

1 replies | 140 view(s)