Activity Stream - Lutron Support Community

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

Today, 01:02 PM

CJFountain replied to a thread Pd-6wcl doa? in Troubleshooting - CAS

Thanks, Kyle; to your questions: 1. I've pulled out the FASS tab until it hits a stop (maybe 3/8"). The lights remain on. 2. Both dimmers are...

2 replies | 17 view(s)

Today, 12:54 PM

CJFountain replied to a thread 3-Way setup with Caseta at one end, motion sensor at the other? in Design Assistance - CAS

Thank you for the quick response! That sounds easy enough. Off to buy a PD-OSENS.... :-)

2 replies | 19 view(s)

Today, 12:17 PM

Kyle L. replied to a thread 3-Way setup with Caseta at one end, motion sensor at the other? in Design Assistance - CAS

Hello. You would replace one of the switches (the motion sensor OR the standard 3-way switch) with the PD-6WCL. The other switch would get replaced...

2 replies | 19 view(s)

Today, 12:08 PM

Kyle L. replied to a thread Pd-6wcl doa? in Troubleshooting - CAS

When you pull out the FASS tab on the bottom of the dimmer, do the lights turn off? Are the dimmers wired as single pole switches or 3-way? Also,...

2 replies | 17 view(s)

Today, 12:03 PM

CJFountain started a thread 3-Way setup with Caseta at one end, motion sensor at the other? in Design Assistance - CAS

I've got a setup that doesn't match anything I've seen in the Forum; I would really appreciate some advice. My entry hallway turns a corner. The...

2 replies | 19 view(s)

Today, 11:51 AM

CJFountain started a thread Pd-6wcl doa? in Troubleshooting - CAS

I'm starting to convert my home to Caseta. I've installed four PD-6WCL dimmers so far. Two of the four have worked flawlessly: they worked...

2 replies | 17 view(s)

Today, 10:48 AM

jdbnsn started a thread Can I power an RRD-W6BRL keypad from what used to be a 4 way switch? in Troubleshooting - RA2

RadioRA2 system. I had a 4 way circuit powering a group of recessed lights. It's got an RRD-6CL master dimmer at the load side, and had two remote...

0 replies | 11 view(s)

Today, 09:59 AM

drewski300 replied to a thread Can you reuse an already registered Connect Bridge on another system? in General Discussion - RA2

I pretty sure you have to unregister the connect bridge from the system through the app. Once removed, you can add the new homeowners. I don't...

5 replies | 167 view(s)