Activity Stream - Lutron Support Community

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

Today, 10:51 AM

Whitenoise replied to a thread Invertor load shed in Programming - HWQS

Sorry for extremely late reply to this. The Invertor is instantaneous. its essntially a whole house UPS and it doest have any power loss.

2 replies | 3124 view(s)

Today, 10:42 AM

Whitenoise started a thread Borehole cut off programming in General Discussion - HWQS

Having a completely brain freeze on this so forgive me if its a simple solution.I have a client that is off mains water in Africa and has a borehole...

0 replies | 4 view(s)

Today, 06:41 AM

Buchers replied to a thread Home and away in General Discussion - HWQS

Hi, Is it possible to control my old Lutron HomeWorks system (illumination) with SmartThings or Google Home? Could you please explain how you created...

8 replies | 2369 view(s)

Today, 05:25 AM

hyi560 replied to a thread Lutron Wireless Switch/Phillips Hue/LIFX in 3rd-party Integration - CAS

I have mostly Lutron caseta dimmer, caseta fan control, n caseta on/off switches with very few leviton smart decora. I only use the Caseta dimmer...

12 replies | 27890 view(s)

Yesterday, 10:01 PM

MitchE replied to a thread Transfer fails Win 10 and 12.6 in Troubleshooting - RA2

Push a firmware update. Sometimes that clears the repeaters brain. How are they both on the network? If possible put them both on the same switch.

2 replies | 36 view(s)

Yesterday, 09:57 PM

MitchE replied to a thread 12.9 Software crashing in Troubleshooting - RA2

I have been getting a lot of crashes 12.7,12.8. Haven't used 12.9 yet. Some times my fix is to create a new file then once the software loads I can...

1 replies | 34 view(s)

Yesterday, 09:46 PM

Vinyou started a thread HVAC systems and repeaters in General Discussion - RA2

HVAC systems and repeatersJust ran into this today found a very interesting motor find out more info didn’t understand if I needed to install a...

0 replies | 17 view(s)

Yesterday, 06:17 PM

jluros replied to a thread 4-way in a 3-way circuit. in Design Assistance - CAS

I'm not sure if there's a way to wire a 4-way circuit to work in a Caseta-controlled circuit. I am using a PD-10NXD, and despite following the...

3 replies | 139 view(s)

Yesterday, 02:56 PM

Josh R. replied to a thread visor control transmitter compatibility in 3rd-party Integration - RA2

Thank you for your post SparkyCoog. Not all the Visor Control remotes are the same. The ones used for Ra2 and HWQS are the same and can be used...

1 replies | 219 view(s)

Yesterday, 02:20 PM

jluros started a thread Will a 4-way switch work in this scenario? in Troubleshooting - CAS

I have 2 3-way mechanical switches and a 4-way mechanical switch between them controlling a light fixture. I replaced the load-side 3-way switch with...

0 replies | 20 view(s)

Yesterday, 02:07 PM

uscpsycho replied to a thread Occupancy sensor issues with Inclusive and Lutron Connect in Programming - RA2

I have Hubitat and just started using it when I bought the new version of the hub which I know requires some work to move everything over. I only had...

3 replies | 113 view(s)

Yesterday, 01:51 PM

wkearney99 replied to a thread Transfer fails Win 10 and 12.6 in Troubleshooting - RA2

aaaand now they're in safe mode. wth?

2 replies | 36 view(s)

Yesterday, 01:49 PM

MichaelWade started a thread replacing current single pole paddle rocker switch in General Discussion - LED

I am in need of some help. You will find a photo of my current single pole paddle rocker switch. I purchased a lutron sunnata touch dimmer product....

0 replies | 14 view(s)

Yesterday, 01:12 PM

wkearney99 started a thread Transfer fails Win 10 and 12.6 in Troubleshooting - RA2

I've set up Inclusive on a new machine that uses Windows 10 Pro x64. I've loaded up a project to edit a timeclock event. It seems to take an...

2 replies | 36 view(s)

Yesterday, 12:10 PM

Brandon511 replied to a thread Trouble with lower/raise in General Discussion - HWQS

Thanks For The Great ConTent Sir. I Will also shaer with my Friend & ones again Thanks a lot.Very well explained. Thanks for the...

2 replies | 260 view(s)

Yesterday, 11:38 AM

D.J. Hall started a thread 12.9 Software crashing in Troubleshooting - RA2

I recently update to RadioRa 2 12.9 software (I must have missed 12.8) and every time I try to open a new project it crashes and never loads past 0%....

1 replies | 34 view(s)

Yesterday, 11:16 AM

Matt H. replied to a thread Caseta Wireless PD-6WCL only turns on and off in Troubleshooting - CAS

What is the make and model of the LED high hats? Have you tried adjusting the low end trim on the dimmer by following the steps on page 66 of the...

1 replies | 64 view(s)

Yesterday, 10:50 AM

kroggemann replied to a thread No ground wire in my light box in Troubleshooting - CAS

Hello,I just installed 1 Lutron Toggler LED+ Dimmer 3-Way Switch (since the lights I wanted to dim were controlled by 2 switches.) It works great!...

2 replies | 340 view(s)

Yesterday, 10:43 AM

BillD replied to a thread Occupancy sensor issues with Inclusive and Lutron Connect in Programming - RA2

The think I like least about the app is that when you turn a dimmer on by pressing the top icon it comes on at 100%. I have my dimmers set at 75%...

3 replies | 113 view(s)

Yesterday, 10:39 AM

Josh R. replied to a thread QSx and Sonos in General Discussion - HWQS

Thank you for post marcon. QSX at this time is not able to integrate with Sonos. We are updating QSX with more features as times passes. We update...

1 replies | 152 view(s)

Yesterday, 09:56 AM

Garrett S. replied to a thread Strobing when motion sensors are triggered in Troubleshooting - CAS

Hi,This kind of issue usually does not happen when controlling halogen or incandescent lighting loads. We would recommend trying to change the lamps...

1 replies | 55 view(s)

Yesterday, 09:51 AM

Mike S. replied to a thread Can't find knobs for old Lutron dimmer switch panel in General Discussion - Legacy Other

Good Morning Larry,Thank you for including the pictures of your dimmer and knobs. The Glyder dimmer is obsolete but we do have replacement knobs for...

2 replies | 115 view(s)

Yesterday, 09:47 AM

Josh R. replied to a thread New Load in General Discussion - HWQS

Thank you for your post oramos. If the link is completely maxed out, there is no way around the 100 device limit. Is this a 1 link processor or 2...

1 replies | 165 view(s)

Yesterday, 09:34 AM

johnmax replied to a thread Website issue in Troubleshooting - RA2

Changed to Standard as well. Looks like it works! I'm glad Lutron is on top of their support forum. Especially since the software has no...

7 replies | 141 view(s)

Yesterday, 03:02 AM

uscpsycho replied to a thread New Feature Requests in General Discussion - HWQS

The fact that this spam was posted over a month ago and hasn't been removed suggests that nobody from Lutron is paying attention and sharing your...

138 replies | 133178 view(s)

Yesterday, 01:40 AM

uscpsycho replied to a thread RadioRA2 Vacancy Sensor Delay Programming in Programming - RA2

This is a super late reply but just came across this thread and thought I'd point out some issues with occupancy sensors. If you use Lutron...

5 replies | 4821 view(s)

01-24-2021, 06:23 PM

Patcallaghan started a thread Caseta Dimmer Flashes on, off, then on. in Troubleshooting - CAS

I’m having trouble after about a year or so with this dimmer. It is a dimmer and a remote in this configuration. Using either the dimmer or the...

0 replies | 34 view(s)

01-24-2021, 03:23 PM

davephan replied to a thread 4 Way Switch Help in Troubleshooting - Controls

I am also having a problem with my Lutron Mastro 3-way dimmer. The power comes to the Lutron Mastro 3-way dimmer, then to a mechanical 4-way switch,...

18 replies | 26218 view(s)

01-24-2021, 02:16 PM

D.J. Hall started a thread Entire House Lights Flickering in Troubleshooting - RA2

This is an odd situation for me. When I originally implemented the RadioRA 2 system at a clients house (one year ago) all tested and configuration...

0 replies | 41 view(s)

01-23-2021, 07:19 PM

Nuggie replied to a thread Can dimmer remember favorite setting? in Programming - CAS

Lutron, are you seriously telling me that my 40 year old rotary dimmer switch can "remember" its dimness setting, but your modern smart dimmer switch...

32 replies | 62267 view(s)