Activity Stream - Lutron Support Community

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

Filter by: Forums

Last 24 Hours

Clear All

Older Activity
Yesterday, 10:17 PM

SparkyCoog started a thread Can you reuse an already registered Connect Bridge on another system? in General Discussion - RA2

I recently updated a Ra2 system to Ra3 and was given the old connect bridge. I believe it's still registered to the old owner. I'm curious what...

see more

0 replies | 9 view(s)
Yesterday, 04:01 PM

mwarning replied to a thread Help with a 3-way Caseta install. in Troubleshooting - CAS

Yup, thanks for the help :)

see more

5 replies | 50 view(s)
Yesterday, 04:00 PM

mwarning replied to a thread Help with a 3-way Caseta install. in Troubleshooting - CAS

Answering my own question. Following this diagram, (the second option is the config I'm using) which makes sense:

see more

5 replies | 50 view(s)
Yesterday, 03:55 PM

Kyle L. replied to a thread Help with a 3-way Caseta install. in Troubleshooting - CAS

It is a bit unclear from that particular diagram. On page 22, it shows both line-side wiring and load-side wiring.

see more

5 replies | 50 view(s)
Yesterday, 03:50 PM

mwarning replied to a thread Help with a 3-way Caseta install. in Troubleshooting - CAS

In that document, I was looking at the instructions for the ELV dimmer (I'm using the PD-5NE-WH). It shows this:

see more

5 replies | 50 view(s)
Yesterday, 03:27 PM

Kyle L. replied to a thread Help with a 3-way Caseta install. in Troubleshooting - CAS

Hello. Not sure where you saw the documentation where it says to connect the black from the Caseta to the load wire that goes to your lights. On the...

see more

5 replies | 50 view(s)
Yesterday, 03:15 PM

mwarning started a thread Help with a 3-way Caseta install. in Troubleshooting - CAS

Looking for a sanity check on an 3-way light circuit that I'm switching out smart switches. Here's the scenario: 1. Box A is a single gang...

see more

5 replies | 50 view(s)