Activity Stream - Lutron Support Community

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

Today, 01:10 PM

abiusom replied to a thread PD-6ANS Multi-Location (3 physical switches) Install Issue - Lights won't turn off in Troubleshooting - CAS

Thanks Randy, obviously by your response I don't have the same setup as this guy.. One of my other posts will be more accurate of the 3 way i have. ...

7 replies | 4208 view(s)

Today, 01:04 PM

michaelothomas replied to a thread Caseta Wireless Switch (non-dimming) Setup Problem in Troubleshooting - CAS

Ah. It seems the three outdoor light bulbs are of the high wattage HID variety. I bet I'm just overloading the switch. Will attempt to swap to LEDs...

2 replies | 32 view(s)

Today, 11:33 AM

Jonathan C. replied to a thread RadioRA 2 GRAFIK T hybrid keypad and non-GRAFIK T companion dimmer 3-way in Design Assistance - RA2

Hello! Thank you for your inquiry. You can use the Grafik T Keypad without a load and use a hard wired dimmer to control the light. This would be the...

1 replies | 84 view(s)

Today, 10:59 AM

simmonap replied to a thread PD-6WCL suddenly started strobing. in Troubleshooting - CAS

I was able to replace all 3 bulbs with a 75W LED replacement (vs 60W LED) and all functionality has returned.

4 replies | 175 view(s)

Today, 07:02 AM

pcola replied to a thread Maestro dimmer only works when other dimmer is on in Troubleshooting - Controls

The problem dimmer is only wired as a single pole. Nothing is connected to the blue terminal. All the neutrals are connected together and all...

2 replies | 37 view(s)

Today, 01:26 AM

abiusom replied to a thread pd-6wcl Dimmer doesn't work in Troubleshooting - CAS

So was it the bulbs?

3 replies | 1216 view(s)

Yesterday, 11:34 PM

randyc replied to a thread PD-6ANS Multi-Location (3 physical switches) Install Issue - Lights won't turn off in Troubleshooting - CAS

At one end, tie all 3 of the wires attached to the switch together. At the middle location(s), tie all 4 wires attached to the switch together. ...

7 replies | 4208 view(s)

Yesterday, 11:21 PM

randyc replied to a thread Maestro dimmer only works when other dimmer is on in Troubleshooting - Controls

Is there anything connected to the blue terminal of the 1st dimmer? The blue is used for communication only. Make sure you don't have anything...

2 replies | 37 view(s)

Yesterday, 11:12 PM

randyc replied to a thread Caseta Wireless Switch (non-dimming) Setup Problem in Troubleshooting - CAS

Try resetting the device back to factory defaults. Triple-tap and hold until the LEDs flash, then triple-tap and release. There is also some info...

2 replies | 32 view(s)

Yesterday, 10:57 PM

abiusom replied to a thread 3way switch - light fixture stays on in Troubleshooting - CAS

Did you cap off 1 red in just one of the boxes, or did you cap both the red wires in each box?

4 replies | 1743 view(s)

Yesterday, 10:38 PM

abiusom replied to a thread PD-6ANS Multi-Location (3 physical switches) Install Issue - Lights won't turn off in Troubleshooting - CAS

Same here, what was the fix??

7 replies | 4208 view(s)

Yesterday, 10:29 PM

abiusom replied to a thread Need Help - Caseta PD-6WCL Seemingly has no power - No indicator lights in Troubleshooting - CAS

I think ive got something similar happening. Did you ever solve this issue?

1 replies | 1014 view(s)

Yesterday, 09:59 PM

abiusom replied to a thread Does Dimmer Pro work with more LEDs? in Troubleshooting - CAS

I have the same issue. Trying to wire a 3-way Caseta PD-6WCL Dimmer - 2 switch locations that control the same 2 light fixtures in a...

2 replies | 346 view(s)

Yesterday, 09:15 PM

abiusom replied to a thread 3 way dimmer switch not responsive, light stays dim and does not turn fully on or off in Troubleshooting - CAS

I have the same issue. Ive been trying to solve it using the advanced PDF instructions from the site, but the closest i can get is either the lights...

2 replies | 294 view(s)

Yesterday, 07:45 PM

michaelothomas started a thread Caseta Wireless Switch (non-dimming) Setup Problem in Troubleshooting - CAS

Hello! I just installed Caseta switches throughout my apartment and I can't get the last switch to make it through the setup process. When I hold the...

2 replies | 32 view(s)

Yesterday, 08:09 AM

pcola started a thread Maestro dimmer only works when other dimmer is on in Troubleshooting - Controls

I don't believe this is a wiring issue, I'm an electrician. I installed these dimmers on a job yesterday. I've never come across an issue like this....

2 replies | 37 view(s)

Yesterday, 02:33 AM

vicyclefive replied to a thread Which App for Which HWQS Designer Version? in General Discussion - HWQS

RadioRA2 is less good than Caseta. The more expensive system doesn't let me issue Alexa commands by room, e.g., "turn off the kitchen lights" - but...

6 replies | 826 view(s)

01-15-2021, 10:32 PM

vining replied to a thread Axing telnet w/ new API not publicly available? No RPM support? What are you thinking in General Discussion - HWQS

They could easily allow both method, Leap for app control through their cloud portal and telnet strictly for LAN based control systems. ...

10 replies | 4298 view(s)

01-15-2021, 05:44 PM

whackit replied to a thread Infratech Heaters and 0-10v. EPC-1-D??? in Design Assistance - RA2

I just did some research and spoke to a very helpful engineer at LVS. It basically is just using the Control as a relay as I thought. You can get...

3 replies | 120 view(s)

01-15-2021, 03:27 PM

fgaeta replied to a thread Move device to new room in General Discussion - Vive

Hi, Adam, thank you for your response, I appreciate your suggest of Vive Guide, but I think that move option could be helper when you need reorganize...

2 replies | 4620 view(s)

01-15-2021, 02:23 PM

CleanRF replied to a thread Issue accessing main repeater with essentials software. in General Discussion - RA2

Lutron Tech support suggested plugging directly into the repeater with an ethernet cable and laptop. Extract project. DO NOT UPDATE firmware before...

5 replies | 263 view(s)

01-15-2021, 01:03 PM

davisadm replied to a thread Multiple Smart Bridge Pro on the same Job? in Design Assistance - CAS

I beg to differ. A Pico is a one way device. Meaning it only transmits, but does not receive any information. A Smart Bridge Pro has no way to know...

2 replies | 81 view(s)

01-15-2021, 11:33 AM

Matt H. replied to a thread Wiring Caseta D-5ANS-WH-R to fan LED light in Troubleshooting - CAS

Being that the Fan is being run by another Lutron control, is the PD-5ANS-WH installed directly next to this device? If so there should be a jumped...

1 replies | 100 view(s)

01-15-2021, 10:50 AM

Gordon Shumway replied to a thread Pfsense VPN in General Discussion - CAS

Why do I want to do this? Lack of trust in other organizations to "protect" my data/network. I have read too many anecdotes proving that technology...

2 replies | 91 view(s)

01-15-2021, 10:06 AM

Matt H. replied to a thread Multiple Smart Bridge Pro on the same Job? in Design Assistance - CAS

Once a Pico remote is paired to a device on one bridge system it will only be for use on that system and would not be able to be added to a second...

2 replies | 81 view(s)

01-15-2021, 02:20 AM

PACHAWAII started a thread Multiple Smart Bridge Pro on the same Job? in Design Assistance - CAS

We are bidding a job and the designer has 2 Smart Bridge Pro and 2 Repeaters. One each upstairs and one each downstairs. Can devices on one system be...

2 replies | 81 view(s)

01-15-2021, 12:12 AM

evankirkhart replied to a thread Pfsense VPN in General Discussion - CAS

I don’t mess with Pfsense, but I do install Ubiquiti hardware. My understanding is that L2TP VPN does not forward multicast, which will prevent the...

2 replies | 91 view(s)

01-14-2021, 10:02 PM

Gordon Shumway started a thread Pfsense VPN in General Discussion - CAS

I have set up Pfsense VPN in my home for my own personal use. When away from home using my mobile phone and authenticated through the VPN I can...

2 replies | 91 view(s)

01-14-2021, 08:40 PM

whackit replied to a thread Infratech Heaters and 0-10v. EPC-1-D??? in Design Assistance - RA2

Th only problem is. The EPC-1-D has been discontinued and replaced by the EPC-2-D which has different wiring than the previous model. So the...

3 replies | 120 view(s)

01-14-2021, 05:41 PM

Matt H. replied to a thread Caseta Dimmer in the foyer controlling a chandelier in Troubleshooting - CAS

Correct. Wires are to be capped in other three way location.

3 replies | 125 view(s)