Activity Stream - Lutron Support Community

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

Yesterday, 10:43 PM

angkelavan replied to a thread Difference between PD-5WS-DV and PD-5ANS-WH-A or PD-5ANS-WH-R in General Discussion - CAS

Swapping the dimmer switch with a three-wire switch and getting the light working shows that the new switch is compatible with your wiring...

6 replies | 6525 view(s)

Yesterday, 10:39 PM

angkelavan replied to a thread Pfsense VPN in General Discussion - CAS

Troubleshooting a VPN can be complicated, and it can be helpful to seek help from a network administrator or someone experienced with Pfsense...

8 replies | 5671 view(s)

Yesterday, 09:34 PM

ambientdiode started a thread Caseta Switches as "Mesh" or "Repeaters" in General Discussion - CAS

I just came across an article in an e-zine called "The IOTPad" (https://theiotpad.com/?s=Lutron+repeater), which I think contains a number of...

0 replies | 21 view(s)

Yesterday, 03:18 PM

SparkyCoog replied to a thread disable LED illumination on wireless repeater in General Discussion - CAS

Do what we used to do with the blinking 12:00 on the old vcrs: electric tape! With white tape you won't even know it's there.

2 replies | 479 view(s)

Yesterday, 03:16 PM

SparkyCoog replied to a thread RadioRA2 to RadioRA3 converion. Device warning question. in General Discussion - RA3

I wish they would do this with Grafik Eye and Grafik T devices for people who upgrade from Ra2 to Ra3. It's ok if they're obsolete but just make what...

2 replies | 174 view(s)

Yesterday, 11:56 AM

DallasTheDog started a thread Selection of Downlighter in the UK in General Discussion - RA2

Hi all, hopefully im the the correct forum. Ive just purchased a RA2 starter kit with dimmer, plus a smart LED downlighter. Evidently the...

0 replies | 22 view(s)

Yesterday, 11:54 AM

Sevenfeet replied to a thread Moving RA3 Processor after system set up.. Is this OK? in General Discussion - RA3

As long as the devices have proper range to the processor, it shouldn't be a problem. Just be careful not to move it somewhere that range problems...

1 replies | 111 view(s)

Yesterday, 08:18 AM

johnmax replied to a thread Phantom Keypad in Designer - What is it used for? in Programming - RA3

Phantom keypads are used when integrating with a control system such as Crestron,Savant, etc.

2 replies | 885 view(s)

Yesterday, 08:06 AM

Jonathan K. replied to a thread Motion Sensor PD-OSens Bracket in General Discussion - CAS

Hello, Here are the part numbers for the mounting brackets for the Caseta Wireless motion sensor (PD-OSENS-WH): 22112327: Corner mount bracket ...

1 replies | 72 view(s)