Activity Stream - Lutron Support Community

Sort By	Time	Show
Recent Recent Popular Popular	Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days	All All Photos Photos Forum Forums

Yesterday, 09:44 AM

ronyboy04 started a thread Support to Community Through Flowers Delivery in General Discussion - CAS

At the point when you request flowers online with any company, you have the alternative to add on quite a few delectable treats and liberal blessing...

2 replies | 36 view(s)

Yesterday, 02:21 PM

416to305 started a thread My RA2 is self installed by myself, but looking at shades and have questions! in General Discussion - Shades

Hi everyone,So I installed RA2 in my house myself by doing the essentials training and going through all that which was pretty easy. I have about...

2 replies | 26 view(s)

Yesterday, 10:34 PM

barko1 started a thread wiring 1 light with dimmer, for dummies in General Discussion - Controls

I have what I think is a simple install. I have a 150w barn light that I am installing on a vertical pole inside. From the light are 3 wires, b, w,...

0 replies | 8 view(s)

Today, 02:49 AM

kramerr replied to a thread IOS App won't connect to Caseta Bridge in Troubleshooting - CAS

I have the same issue. I set the system up and it all worked correctly up until 2 days ago. From outside, using an LTE connection on my iPhone, I...

13 replies | 32828 view(s)

Yesterday, 08:35 PM

mjz3348 replied to a thread H8P5 Battery in General Discussion - Legacy HW

I have an H8P5 processor (H48-120) and would like to know what battery is uses so I can keep project database in memory alive during a power failure....

2 replies | 3078 view(s)

Yesterday, 06:04 PM

Brian W. replied to a thread Upgrading Sivoia QS Wired Shades to Homekit - Need Help v2 in General Discussion - Shades

The QSYC4-RCVR is the previous version of the antenna, which is now the QSYC-J-RCVR. Both antennas will work with all Caseta bridges. As everything...

8 replies | 497 view(s)

Yesterday, 05:29 PM

Matt H. replied to a thread Are all switches 3-way switches if you have a Pico remote? in General Discussion - CAS

There is only one Caseta dimmer that can wire directly to a three way switch and that is the Caseta Pro dimmer PD-10NXD. All other models of Caseta...

1 replies | 88 view(s)

Yesterday, 03:21 PM

cnwinger replied to a thread Help putting together a dimmable voltage setup with a saved dim level preset? in General Discussion - CAS

So, if I approach this differently and just replace the LEDs with non-dimmable 3-watt or similar...is there an easy way to setup multiple zones...

3 replies | 70 view(s)

Yesterday, 03:03 PM

416to305 replied to a thread My RA2 is self installed by myself, but looking at shades and have questions! in General Discussion - Shades

Thanks! Yeah not sure what happened there hopefully this one works better. I honestly haven't even started to look at them yet to know the...

2 replies | 26 view(s)

Yesterday, 02:48 PM

PAR-Designer replied to a thread My RA2 is self installed by myself, but looking at shades and have questions! in General Discussion - Shades

Ha! Isn't that fun when all your formatting is lost! It IS possible to install the shades yourself...both the physical install and the...

2 replies | 26 view(s)

Yesterday, 02:41 PM

Jonathan C. replied to a thread App and bridge issues in Troubleshooting - RA2

Hello! The best resolution we can suggest is to pull a support file from the Main Repeater via the RA2 Essentials/Inclusive software and send it to...

3 replies | 874 view(s)

Yesterday, 11:52 AM

Matt H. replied to a thread Switch turns lights off but not on in Troubleshooting - Controls

Try adjusting the trim on the dimmer seen on the following link. https://www.casetawireless.com/Documents/0301710a_Caseta%20Advanced%20Inst.pdf

1 replies | 50 view(s)

Yesterday, 11:27 AM

Jonathan C. replied to a thread Casey’s PD-6WCL dimmer not working in General Discussion - Controls

Hello, Thank you for your post. It is possible that the wires on the one black wire are Line and Load and are essentially bypassing the switch to...

1 replies | 89 view(s)

Yesterday, 11:27 AM

cnwinger replied to a thread Help putting together a dimmable voltage setup with a saved dim level preset? in General Discussion - CAS

Thank you for the reply. My intention is to have everything dimmed, so I'm not sure how adding more zones would resolve that. An alternative would...

3 replies | 70 view(s)

Yesterday, 10:47 AM

Dorothy B. replied to a thread MSCL-OP153M interferes with garage door in General Discussion - Controls

We are sorry to hear of the issues you are experiencing with your garage door. Can you please verify the model number of the sensor/dimmer, and can...

1 replies | 65 view(s)

Yesterday, 10:39 AM

Josh R. replied to a thread Qsx , Lutron app in General Discussion - HWQS

Thank you for post SparkyCoog. | We understand where you are coming from and our teams are working to get the functionality of the Connect app in...

3 replies | 866 view(s)

Yesterday, 10:32 AM

Dorothy B. replied to a thread Maestro MS-OPS5MH Occupancy sensor wiring in General Discussion - Controls

With the MS-OPS5M sensor switch in a four way application it must be used with two Maestro MA-AS companion on/off switches. Testing/rating wise the...

1 replies | 41 view(s)

Yesterday, 09:57 AM

ronaldodupa replied to a thread Support to Community Through Flowers Delivery in General Discussion - CAS

Totally! With more than 100 years of involvement, the group at https://royalflora.net/en-gb/flower-delivery-ukraine based in Ukraine is focused on...

2 replies | 36 view(s)

Yesterday, 09:49 AM

gracew replied to a thread Support to Community Through Flowers Delivery in General Discussion - CAS

I agree with you ronyboy04 when one need to deliver flowers online yet have no means that you will not be on schedule? Stress not! There are...

2 replies | 36 view(s)

Yesterday, 09:21 AM

Brian W. replied to a thread Serena vs Triathon ? in General Discussion - Shades

The Serena and Triathlon roller shades have the drive on the left side if they are regular roll and the drive on the right side if they are reverse...

2 replies | 1267 view(s)